Direct To Rust Metal Paint July 13th, 2010
How to use your Hammerite Paint…
Preparation
Remove all loose rust, dirt, grease and salt with Hammerite Brush Cleaner & Thinners and rinse with clean water. Allow time to dry.
For painted metal surfaces wash down thoroughly with diluted detergent, rinse with clean water and allow to dry. Paint a small test patch on the painted surface to ensure compatibility with existing paint. Any reaction will occur within the hour. If there is, remove all paint then wash down with degreaser. Rinse with clean water and allow to dry.
For smooth metal surfaces, lightly abrade for maximum adhesion.
On bare zinc, aluminium and galvanized metal surfaces use Hammerite Special Metals Primer before applying Hammerite Direct To Rust Metal Paint.
Note: Special precautions should be taken to avoid inhalation of dust during surface preparation of pre-1960’s paint surfaces as they may contain harmful lead.
Application
Please refer to back of pack for specific application instructions.
Cleaning & Storage
Remove as much paint as possible from equipment before cleaning. For best results use Hammerite Brush Cleaner & Thinners. Hammerite should be stored in a dry well ventilated area. Protect from frost and direct sunlight. DO NOT EMPTY PAINT INTO DRAINS OR WATERCOURSES.
What you will Need
Blunt screwdriver or old knife, wire brush or coarse sandpaper, paint brush or roller, goggles, protective gloves, masking tape, Hammerite Brush Cleaner & Thinners and rags.
Tags;
Hammerite, Paint
